Once AC power has been restored, simply connect the panel's battery wires to the two connection tabs on the battery. For VISTA Panels, it is recommended that you reapply AC Power first. Take the fresh battery and add it to the same location as the old battery. With the cover removed, the backup battery's modular plug can simply be unplugged and removed.ģ. You may need a screwdriver to remove this cover so that the battery can be taken out. You may need a screwdriver to complete this step.įor wireless panels, there will usually be a protective cover holding the battery in place. Disconnect the black and red wires that are connected to the battery's terminals. For VISTA Panels, the backup battery consists of a large black box inside the system. Locate the system's backup battery, and remove it from the system. When the tamper is triggered, press any key on the panel to silence the trouble sound.Ģ. Removing the cover will cause a tamper response from the panel, so make sure that you put the system on test with the monitoring station first if the system is being monitored. Once the back cover is removed, the battery will be exposed. Any tabs can be pressed in, and any screws can be removed using a screwdriver. A key may be required if the cabinet is locked.įor wireless systems, such as LYNX Touch Panels or the Lyric Controller, there are usually tabs or screws holding on the back cover. For Honeywell VISTA Panels, simply open up the metal cabinet that encloses the system. Every battery in a Honeywell System is located on the inside. This can be done by either unplugging the panel's transformer, or by turning off the breaker for the outlet being used to power it.Ĭomplete the following steps to replace the battery in your Honeywell Security System:ġ. It is recommended that you remove AC Power prior to attempting to remove the old battery.

Using an incorrect battery could cause the system to experience permanent damage. Make sure that the battery you add is appropriate for your system. Also remember that different panels will use different types of backup batteries. However, the process is largely the same across every Honeywell Alarm Panel. Keep in mind that the exact steps for removing the battery will vary between different Honeywell Systems. If possible, keep the system transformer plugged into the wall outlet during this process.

Then locate the battery, and use the proper tools to remove the old battery and add the new one. You can replace the battery in your Honeywell Security System by first opening up the system.

Honeywell galaxy alarm change battery